Service

PACKAGE

Small machines are packed by wooden case, large dimention products are specially packed by protect layers.

ACCESSORIES

Small machines are packed by wooden case, large dimention products are specially packed by protect layers.

MAINTENANCE

You may encounter Fault phenomenon and Cause of issue, and provide you with Method of exclusions for reference

Main engine(host) shock

  • The motor and the host are not placed horizontally
  • Fixing screw too loose
  • Install again
  • Add Spring pad and fastening

No pellet outNo pellet out

  • Have not take running-in of machine.
  • Water content too low and not measure out ingredients as proportions
  • Die hole too small and thin
  • Gap between roller and flat die is too big
  • running-in of machine again as reference
  • measure out ingredients as requiring proportions and increase water content
  • replace suitable size of flat die.
  • Adjusting the pressing on both ends of die roller

Failure or difficulty in starting up

  • Voltage is too slow
  • Water content too low and not measure out ingredients as proportions
  • Die hole too small and thin
  • Gap between roller and flat die is too big
  • Find the reason and use machine avoid the peak of electricity consumption
  • Replace big wire replace new capacitor and bearing

Main engine(host) does not work

  • Host gearbox lacking of gear oil
  • ost bearing lock
  • Adjusting wire pressing in die roller too tight
  • Too many more materials put in,and too dry
  • Filling gear oil
  • Cleaning bearing or replace new one
  • Turn loose adjusting wire pressing
  • Remove the excess material and increase water content

Die roller does not work

  • Bearing damage owing to lacking of oil
  • Nut is loose
  • Too much dust inside the bearing
  • lat die and roller are seriously worn
  • Replace bearing and filling butter oil
  • Tighten the nut
  • Cleaning dust
  • Remove flat die,switch to the other side to use,or replace new one

Low output capacity , pellets without stable shape and too soft

  • Too big gap between flat die and roller
  • Too wet or too dry of raw material
  • Too thick of raw material
  • Too little fiver in raw material
  • Appropriate pressing the roller adjusting wire pressing
  • Adjust the water content of raw material
  • Replace thin raw material
  • Increase fiber proportion in raw material

Oil spill

  • Too much fuel filled in the gearbox
  • Oil leakage for oil seal of gearbox shaft
  • Filling gear oil as volume requirement
  • Replace new oil seal
Top